Instructions to configure embedded Node RED development tool in PINEX

Node-RED Version

The embedded version Node-RED in the PINEX gateway firmware 6 is  v3.x

Turn on Node Red

Navigate to Tool on the left panel→ click Node Red → click Star Node-Red then click Open New Tab

Setup Connection

Prerequisite:

The Embedded Chirp Stack Network Server in the PINEX gateway must be active and configured properly to forward data to embedded Node RED development tool. Details to activate and configure embedded Chirp Stack are at the link:

https://daviteq.com/en/manuals/books/manual-for-lorawan-sensor/page/instruction-to-configure-embedded-chirpstack-network-server-in-pinex-firmware-6

Use the  MQTT-in node to receive data from embedded Chirp Stack Network Server

Double click mqtt node → click + Add new mqtt-broker config node and Fill in the following fields

Server: localhost

Port: 1883

Protocol: Select MQTT V3.1.1

Client ID: Leave blank for auto generated

Click Add to save settings

Configure mqtt node following field (after adding mqtt broker)

Topic: application/+/device/+/event/+

QoS: 0

Output: auto-detect

Add debug node and click deploy

Further reference

For further reference on Node RED development tool, please access the referenced document at link:

Low-code programming for event-driven applications : Node-RED