Sample HTML table for troubleshooting 2

No. Phenomena Reason Solution
1 The wireless transmitter is still running and sending data, however, all the measurement parameters are not updated with new values The connection between the AG tilt sensor and the wireless transmitter is broken Contact the manufacturer for repair or replacement
The battery is almost draining off Check the battery status and replace it when necessary
2 The measured values are not as expected The installation direction is not correct Re-check the installation
The sensor is drifting Contact the manufacturer for repair or replacement
The calibration position or calibration process is incorrect Re-calibrate the device with right position and right process
3 The reading values are very noisy even though the sensor is in a standstill position. The sensor AG tilt sensor got a problem Contact the manufacturer for repair or replacement
External factors at installation location such as wind, vibration, temperature, sun, heat might affect the tilt value External factors such as wind, vibration, temperature, sun, heat at installation location
4 The value of HW_Error equal 1 The lost connection between the AG sensor and the wireless transmitter Contact the manufacturer for repair or replacement
The sensor AG sensor got a problem Contact the manufacturer for repair or replacement

 


Revision #3
Created Mon, Sep 11, 2023 7:43 PM by Phan Van Luc
Updated Tue, Sep 12, 2023 2:19 AM by Phan Van Luc