Sample HTML table for troubleshooting 2

No.

Phenomena

Reason

Solution

1

The wireless transmitter is still running and sending data, however, all the measurement parameters are not updated with new values

The connection between the AG tilt sensor and the wireless transmitter is broken

Contact the manufacturer for repair or replacement

The battery is almost draining off

Check the battery status and replace it when necessary

2

The measured values are not as expected

The installation direction is not correct

Re-check the installation

The sensor is drifting

Contact the manufacturer for repair or replacement

The calibration position or calibration process is incorrect

Re-calibrate the device with right position and right process

3

The reading values are very noisy even though the sensor is in a standstill position.

The sensor AG tilt sensor got a problem

Contact the manufacturer for repair or replacement

External factors at installation location such as wind, vibration, temperature, sun, heat might affect the tilt value

External factors such as wind, vibration, temperature, sun, heat at installation location

4

The value of HW_Error equal 1

The lost connection between the AG sensor and the wireless transmitter

Contact the manufacturer for repair or replacement

The sensor AG sensor got a problem

Contact the manufacturer for repair or replacement