Module CAP10CNC

USER GUIDE FOR MODULE CAP10CNC



FEB-2020

This document is applied for the following products

1. Module CAP10CNC

2. Specification

Output

4-20mA output (with 250 ohms precision resistor), or RS485/ModbusRTU

Power supply

8..50VDC

Consumption

max 35mA

Capacitance range

0-400 pF

Working temperature

-40 oC .. + 85 oC

3. Instructions for configuration

3.1 Wiring

Please wiring as shown below:

3.2 Soldering wire connected to input C signal

Solder the signal C to the middle point of the circuit.

Choose 1 of 3 points on the edge of the circuit (1 or 2 or 3) to connect GND.

3.3 Calibration

Zero: Power the circuit, press the button 3 times consecutively then wait for the LED to blink continuously, we will press one more time. Disconnect power.

Full-scale: Power the circuit, press the button 3 times consecutively then wait for the LED to blink continuously, we will hold the button, when the light is off we take our hands off.