Recently Updated Pages
Sigfox OZONE Sensor WSSFC-G4-O3
SKU: WSSFC-G4-O3 Doc No: WSSFC-G4-O3-DS-EN-10 Introduction WSSFC-G4-O3 is a Sigfox sensor wi...
III. Offline configuration for iConnector
iConnector need to be configured properly so that it is able to connect to Globiots Server succes...
USER GUIDE FOR WIRELESS AMBIENT OXYGEN SENSOR WS433-O2
WS433-O2-MN-EN-01 AUG-2021 This document is applied for the following products SKU ...
Sigfox Piezo-Electric 10KHz Vibration Sensor WSSFC-V1A
SKU: WSSFC-V1A Doc No: WSSFC-V1A-DS-EN-10 Introduction WSSFC-V1A is a cost effective, Sigfox...
USER GUIDE FOR ICONNECTOR 3G INTEGRATED WIRELESS CO-ORDINATOR STHC-ISG02DB-WS433-CL-04
STHC-ISG02DB-WS433-CL-04-MN-EN-01 FEB-2020 This document is applied for the following prod...
AMBIENT & PROCESS Humidity & Temperature Sensor with Modbus output MBRTU-ATH
SKU: MBRTU-ATH Doc No: MBRTU-ATH-DS-EN-10 Introduction MBRTU-ATH Humidity and Temperature Se...
USER GUIDE SALINITY SENSOR WITH MODBUS RTU OUTPUT MBRTU-SAL
JUL-2021 This document is applied for the following products 1. Introduction MBRTU-SAL is...
USER GUIDE FOR TURBIDITY SENSOR WITH MODBUS RTU OUTPUT MBRTU-TBD
JUL-2021 This document is applied for the following products 1. Introduction MBRTU-TBD is ...
User Guide For Free Chlorine Sensor with Analog output A420-FCL
A420-FCL-01 JUN-2021 This document is applied for the following products 1. Introduction ...
Dashboard Design Template for iConnector with Sub-GHz Wireless Sensors
1. Diagnostic Dashboard for Cellular iConnector with Sub-GHz Wireless Sensor Guide to use I...
XI. Troubleshooting iConnector and Globiots
No. Phenomena Reason Solutions 1 Cannot read modbus No power supply, the power cord is in...
X. Configuring special functions of iConnector on Globiots
IX. Alarm & Event Configuration for iConnector STHC on Glbiots
VIII. Parameter Configuration for iConnector STHC on Globiots
VII. Modbus Configuration for iConnector STHC on Globiots
VI. How to add iConnector STHC to Globiots Server System?
General Information
STHC-MN01-EN-01 JUL-2020 This document is applied for the following products SKU STHC HW...
V. Installation iConnector STHC
5.1 Example application iConnector is used widely in many applications for Smart Factory, Smart ...
IV. Insert SIM Card for Cellular iConnector
Steps to insert SIM card: Step 1: Remove the housing Using L hex key to unscrew M4 screws at th...
I. Specification of iConnector STHC
1.1 Introduction STHC is a Smart IoT Gateway, aka iConnector, a main component in any IoT applic...